Unable to enable Guest Network via OvrC | Voters

Unable to enable Guest Network via OvrC

Jonathan Frye

I attempted to use OvrC to enable a previously-setup Guest Network. (Funny story, I was trying to show my techs how easy it was versus Luxul, and it didn't work.) "Error: Something went wrong" in an orange pop-up in the top-right corner.

July 27, 2020

Nima

Which AP are you using? I just tried it and it worked on my unit. can you please screen shot the error message you are getting?

Jonathan Frye

Nima: 3x WA-4200 and 1x WA-2200-O. So far only two of the WA-4200s have enabled the 2.4Ghz band without issue. None of them enable the 5G band.

EDIT: It seems like disabling the Guest Networks is also problematic. One of the two that did enable the 2G would not disable it. I went into the AP's GUI to disable. It also seems like after every change in OvrC the AP is rebooting, just like it would after hitting "Apply" on the local GUI. Can OvrC for these APs be modified to mirror the AP where you configure your settings then "Apply"? Otherwise it's going to take a solid 10 minutes to enable 2G+5G Guest Networks versus 3 minutes by just using the AP GUI.

Nima

Jonathan Frye: Would you mind sharing your config file so we can load and try internally?

Jonathan Frye

Nima: Where can I email the configs?

Nima

Jonathan Frye: Can you share a dropbox link or attach it to ths post here please? our server may block the email.

Jonathan Frye

Nima: https://drive.google.com/file/d/1DJld9QEdxgw1ynLLB1NcqfDv_TRRBaEF/view?usp=sharing
https://drive.google.com/file/d/10fJoYbncusIL8Vcmmw6-lZTOCJ5S73cS/view?usp=sharing
https://drive.google.com/file/d/1rT8qF1u3X7OXo7jVF_Px7Od5MrZ9Fr8Z/view?usp=sharing
https://drive.google.com/file/d/1hl58myxuE2BZAUZ1glr63wXMM87sIgpu/view?usp=sharing